PLEASE SELECT THE DESTINATION COUNTRY AND LANGUAGE :
상품명 | 에어봇 Omnibus F4 V5 컨트롤 보드 |
---|---|
판매가 | 38,000원 |
적립금 | 380원 (1%) |
배송비 | 3,500원 (50,000원 이상 구매 시 무료) |
제조사 | 에어봇 |
구매수량 | |
원산지 | 중국 |
코드명 | P0000XTY |
결제안내
현금결제 | 세금계산서 발행 | 도서산간 배송비 추가
|
배송비
무료 ~ 3,000원 (30만원 이상 무료) | 도서산간 배송비 추가
|
The omnibus series of flight controllers are known to be the best all in one integrated flight controller, using the best selection of sensors and parts at a great price and small form factor. Now the latest addition to the series uses the performance STM32 F405 MCU. The omnibus F4 uses the MPU6000/ICM-20608 IMU over SPI for the super fast gyro updates (up to 32Khz) to keep up with the fast F4 MCU, allowing you to run your betaflight/iNav control loop insanely fast. This gives you the extra edge when racing your FPV quadcopter.
The AB7456 OSD chip (an upgraded MAX7456) allows for direct configuration and updates directly within betaflight. This OSD chip uses much less power than the older MAX7456 OSD Chip, but the main benefit is that it can be configured directly within betaflight, no need for an external FTDI, or jumper switches. In addition the omnibus F4 includes a high performance 5V, 1.5A STM L78 voltage regulator which help filter the power and adds voltage protection to the board.
The V5 omnibus includes a current source selection jumper (see pinout below for more details), also the omnibus f4 v5 uses a new 8 pin Sh 1.0 Socket to make connecting a 4in1 ESC much easier. This is compatible with up to 6S batteries.
The V4 omnibus main feature is that the solder jumper to selected between PPM/SBUS is no longer needed. The board also features some minor hardware revisions to increase the boards robustness even more.
The V3 fixes some of the LDO problems of the V2, so now you can power this board directly from your battery (up to 4S Lipo)
We do not include nay pin headers with this board, but we do sell them separately, you will also need to get a micro SD card if you want to use blackbox logging.
If you have problems connecting to the board, or uploading new firmware the best fix is to use the zadig driver tool.
The V5 omnibus includes a current source selection jumper (see pinout below for more details), also the omnibus f4 v5 uses a new 8 pin Sh 1.0 Socket to make connecting a 4in1 ESC much easier.
This v4 pinout is for people who still use the older version. The notable feature of the V4 board is that the SBUS/PPM solder selector jumper has been removed, now you can just connect your receiver to J7 and select the type within betaflight.
The pinout was kept here for previous customer still flying on the V3 omnibus.
There is a known bug with betaflight that can sometimes prevent you from switching between SBUS and PPM. You need to first select serial RX and sbus in the configuration tab, save. Then go turn on serial RX on the UART 6 port in the ports tab and save. Then go back between the two to make sure the settings have been saved correctly as sometimes it does not save properly.
Inverted and non-inverted SBUS
Spektrum DSM